china vertical turret milling machine bed belongs to the category of electric processing, China is the first line cutting for industrial production of the country, from the social environment, China's implementation of the market economy is not long, Some small china vertical turret milling machine bed production plants are still in the accumulation stage of the original capital, these manufacturers often do not have the machine manufacturing capacity, can only be assembled production line, the quality control of the whole process of production is out of the question, R D, innovation is even more impossible. There are a large number of such manufacturers in the eastern region of China. In addition, the laws supporting the market economy in China are still immature, and the local government protection is driven by interests, so these enterprises with no production capacity will continue to survive. From the current situation, the attitude of the state is to eliminate them naturally through market competition.

According to the running speed of the electrode wire, the EDM china vertical turret milling machine bed is usually divided into two categories: One is the high-speed EDM china vertical turret milling machine bed, the electrode wire for high-speed reciprocating movement, the general wire speed is 8 ~ 10m/s, the electrode wire can be reused, the processing speed is high, but the fast wire is easy to cause the electrode wire shake and reverse pause. Reduce the processing quality, is the main type of production and use of our country, but also our country's EDM machining mode; The other is the low-speed EDM china vertical turret milling machine bed, the electrode wire for low-speed unidirectional movement, the general wire speed is less than 0.2m/s, the electrode wire discharge is no longer used, the work is stable, uniform, small jitter, good processing quality, but the processing speed is low. It is the main type of machine produced and used abroad. Next, we will briefly introduce how to install silk correctly in the use of china vertical turret milling machine.

1, in the process of wire loading to maintain a certain tension in the process of wire loading to use the hand to hold the molybdenum wire wheel to maintain a certain tension, if there is no tension easy to cause the phenomenon of yarn and silk slip out of the guide wheel.

2, the wire into the reverse wheel, the installed molybdenum wire should be inserted into the guide wheel, to avoid the friction and wear of the molybdenum wire and the frame caused damage to the frame, while reducing the service life of the molybdenum wire.

3, to have enough wire length, the wire cutting processing of the wire cylinder is a reciprocating motion of the wire cylinder wire width should be at least more than half of the width of the wire cylinder slightly less than the width of the wire cylinder.

4, keep the wire perpendicular to the table? After the electrode wire is wound and tensioned, the perpendicularity of the electrode wire to the table should be corrected and adjusted. In production practice, simple tools are mostly used. (such as a straight ruler, cylindrical ruler or regular hexahedron), with the working face (or the fixture table placed on it) as the inspection basis, visually test whether the gap between the electrode wire and the tool surface is consistent, and adjust it until the gap is consistent.

5, after the silk is installed, it is necessary to re-tensioning the general EDM china vertical turret milling machine bed has molybdenum wire tensioning device, and there is no tensioning device for the silk frame china vertical turret milling machine bed. The wire should be tightened with a hand wheel before processing.

china vertical turret milling machine https://www.talentcnc.com/Turret-milling-machine